Up

http://www.soundtraxx.com/products/dcc/tsunamidecoders.htm for detailed specifications

Top of the line sound decoders

Each decoder includes:

The following are features of the Tsunami that are in addition to the features of competitive sound systems.

• Uses 9 Pin JST connector. i.e. you can remove your non-sound decoder and replace it with a Tsunami!

• Over 22 steam sound effects including the bell, air pump, exhaust chuff, coupler, steam release, cylinder cocks, snifter valves, brake release, side rod clank, Johnson bar/power reverse, blower, injector, pop valve, water stop and Fireman Fred.

• 24 individual volume settings

• "Playable" Whistle

• Dynamic Digital Exhaust Processor (DDE)

• Digital Reverb

• Multi-Band Equalizer

• 2048 Speed Steps

• Ultra-sonic PWM Frequency Adjustable to 39KHz

• LED Brightness Correction

Currently 5 models:

Retail:$119.00    Special Train Buddy price is $95.20

Digitrax Announces:

•     PS2012 (A 20 AMP power supply!)

•     UT-4 and UT-4R (An "easy to use" throttle.  Radio too!)

•     BDL168 (replacement for BDL162.  More functions, smaller size)

•     BD4 (replacement for BD1.  More functions.)

PS2012

20 Amp Power Supply for DCC

·         Regulated power supply gives more booster power with less heat.

·         Run up to four 5 amp command stations and/or boosters with this supply.

·         Scale selectable DC output voltage

N scale 13.8VDC 20Amps

HO Scale 18.0VDC 15Amps

G Scale 23.0VDC 12Amps

·         DC Ammeter

·         On/Off Switch

·         2 Output Connector Posts accept spade lugs or banana plugs

·         Integral cooling fan

·         Design coordinated to match your other Digitrax system components

$179.99 MSRP   $143.99 Train Buddy (20% off!)   

Back to Top

UT4

Utility Throttle

·         Simple to use throttles

·         Cost effective

·         Large knob for speed control

·         3 position toggle switch for direction control and braking

·         Manual dials for 4 digit loco address selection

·         Address range 00-9,000+

·         Use with any LocoNet System

·         Control Functions F0-F12

·         UT4 is infrared equipped with a coiled cord

$79.95 MSRP        $63.96 Train Buddy (20% off!)

Back to Top

UT4R

Radio Equipped Utility Throttle

·         UT4R is radio and infrared equipped with a short flat cord

$129.99 MSRP        $103.98 Train Buddy (20% off!)

Back to Top

BDL168

LocoNet Occupancy Detector

(Replaces BDL162)

·         Cost Effective occupancy detection for 16 detection sections

·         Outputs for panel mounted LEDs to display local occupancy & power zone status

·         Can be connected to LocoNet to transmit occupancy information to your LocoNet System

·         Detects any powered locomotive

·         Detects un-powered rolling stock equipped with resistor wheel sets

·         Improved Digitrax Transponding in 8 zones by adding 2 RX4 Transponder Receivers (sold separately)

·         Ops Mode Read Back allows you to read back CV Values on the mainline using Transponding

MSRP $149.99        $119.99 Train Buddy (20% off!)

Back to Top

BD4

Quad Occupancy Detector

(Replaces BD1)

·         Cost Effective occupancy detection for 4 detection sections

·         Outputs for panel mounted LEDs to display occupancy

·         Detects any powered locomotive

·         Detects un-powered rolling stock equipped with resistor wheel sets

·         Can transmit occupancy information to your LocoNet System using DS54/64 or SE8C (sold separately).

$29.95 MSRP        $23.96 Train Buddy (20% off!)

Back to Top

Contact us at 919-562-4378 or e-mail:info@trainbuddy.com

(c) Copyright 2002-2007, K.A Parker & Associates, Inc.  All rights reserved

This page was last updated: 2008-06-18